Dell Networking S4810, Reference Manual

Page: 962 / 1761

Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.5.1.0 Introduced on the E-Series.
Usage
Information To perform protocol-support consistency checks on hello packets, use this
command. The adjacency-check is enabled by default.
advertise
Leak routes between levels (distribute IP prefixes between Level 1 and Level 2 and vice versa).
S4810
Syntax
advertise {level1-into-level2 | level2-into-level1} prefix-
list-name
To return to the default, use the
no advertise {level1-into-level2 |
level2-into-level1}[ prefix-list-name ]
command.
Parameters
level1-into-
level2 Enter the keywords
level1-into-level2
to advertise
Level 1 routes into Level 2 LSPs. This setting is the default.
level2-into-
level1 Enter the keywords
level2-into-level1
to advertise
Level 2 inter-area routes into Level 1 LSPs. This behavior is
described in RFC 2966.
prefix-list-
name Enter the name of a configured IP prefix list. Routes meeting
the criteria of the IP Prefix list are leaked.
Defaults level1-into-level2 (Level 1 to Level 2 leaking enabled.)
Command
Modes
• ROUTER ISIS ( for IPv4 )
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 ( for IPv6 )
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
962
Intermediate System to Intermediate System (IS-IS)