Dell Networking S4810, Reference Manual

Page: 1623 / 1761

storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic allowed into the C-Series and S-Series
networks only.
S4810
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the
no storm-
control multicast packets_per_second in
command.
Parameters
packets_per_se
cond
in
Enter the packets per second of multicast traffic allowed into
the network. The range is from 0 to 33554368.
Defaults none
Command
Modes CONFIGURATION (conf)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-series and S-Series.
Usage
Information Broadcast traffic (all 0xFs) should be counted against the broadcast storm control
meter, not against the multicast storm control meter. It is possible, however, that
some multicast control traffic may get dropped when storm control thresholds are
exceeded.
Storm Control
1623