Dell Networking S4810, Reference Manual

Page: 261 / 1761

Dell(config-ext-macl)#exit
Dell(conf)#do show mac accounting access-list snickers
interface g0/47 in
Extended mac access-list snickers on GigabitEthernet 0/47
seq 10 permit any any ev2 eq 800 count bytes (559851886
packets 191402152148
bytes)
seq 20 permit any any ev2 eq 806 count bytes (74481486 packets
5031686754
bytes)
seq 30 permit any any ev2 eq 86dd count bytes (7751519 packets
797843521 bytes)
Related
Commands
mac access-list standard — configures a standard MAC access list.
show mac accounting access-list — displays MAC access list configurations and
counters (if configured).
permit
To pass packets matching the criteria specified, configure a filter.
S4810
Syntax
permit {any | host mac-address | mac-source-address mac-source-
address-mask } {any | host mac-address | mac-destination-address
mac-destination-address-mask } [ ethertype operator ] [count
[byte]] | [log] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
• Use the
no permit {any | host mac-address | mac-source-address
mac-source-address-mask } {any | mac-destination-address mac-
destination-address-mask }
command.
Parameters
any Enter the keyword
any
to forward all packets.
host Enter the keyword
host
then a MAC address to forward
packets with that host address.
mac-source-
address Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask (OPTIONAL) Specify which bits in the MAC address must
match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Access Control Lists (ACL)
261