Dell Networking S4810, Reference Manual

Page: 1094 / 1761

Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords
priority-tagged
then the Layer 2
priority. The range is from 0 to 7.
Defaults unconfigured.
Command
Modes CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
advertise med location-identification
To advertise a location identifier, configure the system.
S4810
Syntax
advertise med location-identification {coordinate-based value |
civic-based value | ecs-elin value }
To return to the default, use the
no advertise med location-
identification {coordinate-based value | civic-based value |
ecs-elin value }
command.
Parameters
coordinate-
based
value
Enter the keywords
coordinate-based
then the
coordinated based location in hexadecimal value of 16 bytes.
1094
Link Layer Discovery Protocol (LLDP)