Dell Networking S4810, Reference Manual

Page: 258 / 1761

mac-destination-address-mask } [ ethertype-operator ] [count
[byte]] [log] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
• Use the
no deny {any | host mac-address | mac-source-address
mac-source-address-mask } {any | host mac-address | mac-
destination-address mac-destination-address-mask }
command.
Parameters
any Enter the keyword
any
to drop all packets.
host mac-
address
Enter the keyword
host
and then enter a MAC address to
drop packets with that host address.
mac-source-
address Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
mac-
destination-
address Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
mac-
destination-
address-mask
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
ethertype
operator (OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
•
ev2
- is the Ethernet II frame format
•
llc
- is the IEEE 802.3 frame format
•
snap
- is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword
count
to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes
processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log
to log the
packets.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
258
Access Control Lists (ACL)