Dell Networking S4810, Reference Manual

Page: 430 / 1761

neighbor peer-group (assigning peers)
Allows you to assign one peer to an existing peer group.
S4810
Syntax
neighbor ip-address peer-group peer-group-name
To delete a peer from a peer group, use the
no neighbor ip-address peer-
group peer-group-name
command.
Parameters
ip-address Enter the IP address of the router to be included in the peer
group.
peer-group-
name Enter the name of a configured peer group.
Defaults Not configured.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
You can assign up to 256 peers to one peer group.
When you add a peer to a peer group, it inherits all the peer group’s configured
parameters. A peer cannot become part of a peer group if any of the following
commands are configured on the peer:
• neighbor advertisement-interval
• neighbor distribute-list
• neighbor route-map
• neighbor route-reflector-client
430
Border Gateway Protocol