Dell Networking S4810, Reference Manual

Page: 1706 / 1761

interface management
Associates a management port with a management VRF.
S4810
Syntax
interface management
To delete the association between a management port and a management VRF,
use the
no interface management
command.
Defaults None.
Command
Modes VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to associate a management port with a management VRF.
When you execute this command, the management ports corresponding to both
the ACTIVE unit as well as the STANDBY unit are associated with the management
VRF.
maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
S4810 S6000
Syntax
maximum dynamic-routes limit {
warn-threshold
threshold-value |
warning-only
}
To remove the limit on the maximum number of routes used, use the
no maximum
dynamic-routes
command.
Parameters
limit Maximum number of routes allowed in a VRF. Valid range is
from 1 to 16,000 (or maximum allowable for that platform if
smaller value).
warning-
threshold Warning threshold value is expressed as a percentage of the
limit value. When the number of routes reaches the specified
percentage of the limit, a warning message is generated.
Valid range is 1 to 100. When warn-threshold is used, once
1706
Virtual Routing and Forwarding (VRF)