Dell Networking S4810, Reference Manual

Page: 1089 / 1761

Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Before LLDP can be configured on an interface, it must be enabled globally from
CONFIGURATION mode. This command places you in LLDP mode on the
interface; it does not enable the protocol.
When you enter the
LLDP
protocol in the Interface context, it overrides global
configurations. When you execute the
no protocol lldp
from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
S4810
Syntax
show lldp neighbors [ interface ] [detail]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet
then the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
detail (OPTIONAL) Enter the keyword
detail
to display all the TLV
information, remote management IP addresses, timers, and
LLDP tx and rx counters.
Defaults none
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1.
(0.0) Modified output of detail parameter to display remote
management IP addresses.
Link Layer Discovery Protocol (LLDP)
1089