Dell Networking S4810, Reference Manual

Page: 1253 / 1761

3DES - 48 or 96 hex digits; DES - 16 or 32 hex digits; AES-
CBC -32 or 64 hex digits for AES-128 and 48 or 96 hex digits
for AES-192.
authentication-
algorithm Specifies the authentication algorithm to use for encryption.
Valid values are
MD5
or
SHA1
.
key-
encryption-
type
(OPTIONAL) Specifies if the authentication key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits
(non-encrypted) or 80 hex digits (encrypted).
Defaults Not configured.
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0) Introduced on the S4810 and Z9000.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Version
8.3.19.0 Introduced on the S4820T.
Usage
Information
Before you enable IPsec encryption on an OSPFv3 interface, first enable IPv6
unicast routing globally, configure an IPv6 address and enable OSPFv3 on the
interface, and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or
encryption) on the router. Configure the same encryption policy (same SPI and key)
on each OSPFv3 interface in a link.
To remove an IPsec encryption policy from an interface, enter the
no ipv6 ospf
encryption spi number
command. To remove null authentication on an
interface to allow the interface to inherit the authentication policy configured for
the OSPFv3 area, enter the
no ipv6 ospf no ipv6 ospf encryption null
command.
Open Shortest Path First (OSPFv2 and OSPFv3)
1253