Dell Networking S4810, Reference Manual

Page: 1659 / 1761

show ntp status
Display the current NTP status.
S4810
Syntax
show ntp status
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information The following describes the
show ntp status
command shown in the Example
below.
Field Description
“Clock is...” States whether or not the switch clock is synchronized,
which NTP stratum the system is assigned and the IP
address of the NTP peer.
“frequency is...” Displays the frequency (in ppm), stability (in ppm) and
precision (in Hertz) of the clock in this system.
“reference time
is...” Displays the reference time stamp.
“clock offset is...” Displays the system offset to the synchronized peer and the
time delay on the path to the NTP root clock.
“root dispersion
is...” Displays the root and path dispersion.
“peer mode is...” State what NTP mode the switch is. This should be Client
mode.
System Time and Date
1659