Dell Networking S4810, Reference Manual

Page: 392 / 1761

reuse (OPTIONAL) Enter a number as the reuse value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is less than the reuse value, the flapping route is once
again advertised (or no longer suppressed). The range is from
1 to 20000. The default is
750 .
suppress (OPTIONAL) Enter a number as the suppress value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is greater than the suppress value, the flapping route is
no longer advertised (that is, it is suppressed). The range is
from 1 to 20000. The default is
2000 .
max-suppress-
time (OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is from 1 to 255. The default is
60 minutes .
route-map
map-name
(OPTIONAL) Enter the keyword
route-map
then the name
of a configured route map.
Only
match
commands in the configured route map are
supported.
Defaults Disabled.
Command
Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
If you enter the
bgp dampening
command, the default values for
half-life
,
reuse
,
suppress
, and
max-suppress-time
are applied. The parameters are
position-dependent; therefore, if you configure one parameter, configure the
parameters in the order they appear in the CLI.
Route refresh is sent when you enable BGP dampening.
392
Border Gateway Protocol