Dell Networking S4810, Reference Manual

Page: 1752 / 1761

virtual-address
Configure up to 12 IP addresses of virtual routers in the VRRP group. To start sending VRRP packets, set at
least one virtual address for the VRRP group.
S4810
Syntax
virtual-address ip-address1 [ ... ip-address12 ]
To delete one or more virtual IP addresses, use the
no virtual-address ip-
address1 [ ... ip-address12 ]
command.
Parameters
ip-address1 Enter an IP address of the virtual router in dotted decimal
format. The IP address must be on the same subnet as the
interface’s primary IP address.
... ip-address12 (OPTIONAL) Enter up to 11 additional IP addresses of virtual
routers in dotted decimal format. Separate the IP addresses
with a space. The IP addresses must be on the same subnet
as the interface’s primary IP address.
Defaults Not configured.
Command
Modes VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced support for telnetting to the VRRP group IP
address assigned using this command.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
1752
Virtual Router Redundancy Protocol (VRRP)