Dell Networking S4810, Reference Manual

Page: 1286 / 1761

Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series on port-channels and the S-
Series.
Usage
Information The router with the largest value assigned to an interface becomes the designated
router. If two interfaces contain the same designated router priority value, the
interface with the largest interface IP address becomes the designated router.
ip pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command
prevents the PIM-SM router from creating state based on multicast source and/or group.
S4810
Syntax
ip pim join-filter ext-access-list {in | out}
To remove the access list, use the
no ip pim join-filter ext-access-list
{in | out}
command.
Parameters
ext-access-list Enter the name of an extended access list.
in Enter this keyword to apply the access list to inbound traffic.
out Enter this keyword to apply the access list to outbound
traffic.
Defaults none
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
1286
PIM-Sparse Mode (PIM-SM)