Dell Networking S4810, Reference Manual

Page: 262 / 1761

mac-
destination-
address Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
mac-
destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
ethertype
operator (OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
•
ev2
- is the Ethernet II frame format
•
llc
- is the IEEE 802.3 frame format
•
snap
- is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword
count
to count packets the
filter processes.
byte (OPTIONAL) Enter the keyword
byte
to count bytes the filter
processes.
log (OPTIONAL, E-Series only) Enter the keyword
log
to log the
packets.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
NOTE: For more information, refer to the Flow-based
Monitoring section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide .
Defaults Not configured.
Command
Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
262
Access Control Lists (ACL)