Dell Networking S4810, Reference Manual

Page: 1595 / 1761

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series, S55.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information To block a type of message parameter, set the logging trap level to a lower
number. For example, to block severity messages at level 6, set the level to 5.
Related
Commands
logging — enables the logging to another device.
logging on — enables logging.
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
S4810
Syntax
show logging [ number | history [reverse][ number ] | reverse
[ number ] | summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the
output. The range is from 1 to 65535.
history (OPTIONAL) Enter the keyword
history
to view only
information in the Syslog history table.
reverse (OPTIONAL) Enter the keyword
reverse
to view the Syslog
messages in FIFO (first in, first out) order.
summary (OPTIONAL) Enter the keyword
summary
to view a table
showing the number of messages per type and per slot. Slots
*7* and *8* represent RPMs.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Simple Network Management Protocol (SNMP) and Syslog
1595