Dell Networking S4810, Reference Manual

Page: 1186 / 1761

Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a designated router
or backup designated router.
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.
ip ospf retransmit-interval
Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the
interface.
S4810
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the
no ip ospf retransmit-interval
command.
Parameters
seconds Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is
5
seconds .
This interval must be greater than the expected round-trip
time for a packet to travel between two routers.
Defaults 5 seconds
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
1186
Open Shortest Path First (OSPFv2 and OSPFv3)