Dell Networking S4810, Reference Manual

Page: 561 / 1761

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
dcbx version
Configure the DCBX version used on the interface.
S4810
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the
dcbx version {auto | cee | cin |
ieee-v2.5}
command.
Parameters
auto | cee | cin
| ieee-v2.5 Enter the DCBX version type used on the interface, where:
•
auto
: configures the port to operate using the DCBX
version received from a peer.
•
cee
: configures the port to use CDD (Intel 1.01).
•
cin
: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
•
ieee-v2
: configures the port to use IEEE 802.1az (Draft
2.5).
Defaults Auto
Command
Modes INTERFACE PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Data Center Bridging (DCB)
561