Dell Networking S4810, Reference Manual

Page: 813 / 1761

Parameters
number Enter the number of links in a LAG that must be in “oper up”
status. The range is from 1 to 16. The default is
1 .
Defaults 1
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0 Introduced on the E-Series.
Usage
Information
If you use this command to configure the minimum number of links in a LAG that
must be in “oper up” status, the LAG must have at least that number of “oper up”
links before it can be declared as up. For example, if the required minimum is four,
and only three are up, the LAG is considered down.
port-channel failover-group
To configure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
S4810
Syntax
port-channel failover-group
To remove all LAG failover groups, use the
no port-channel failover-group
command.
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
Interfaces
813