Dell Networking S4810, Reference Manual

Page: 443 / 1761

Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information Loopback interfaces are up constantly and the BGP session may need one
interface constantly up to stabilize the session. The
neighbor update-source
command is not necessary for directly connected internal BGP sessions.
Neighbors are sorted according to the source and destination ip addresses. If an
update-source ip address exists, then the source ip address determines the order in
which the neighbors are displayed.
neighbor weight
Assign a weight to the neighbor connection, which is used to determine the best path.
S4810
Syntax
neighbor { ip-address | peer-group-name } weight weight
To remove a weight value, use the
no neighbor { ip-address | peer-
group-name } weight
command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-
name Enter the name of the peer group to disable all routers within
the peer group.
weight Enter a number as the weight. The range is from 0 to 65535.
The default is
0 .
Defaults 0
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol
443