Dell Networking S4810, Reference Manual

Page: 93 / 1761

Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.2) Added support for the
fcoe
parameter on the S4810 and
S4820T.
Version 9.1.
(0.0) Added support for OpenFlow on the Z9000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Added the keywords
fcoeacl
and
iscsioptacl
on the
S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the keywords
ecfmacl
,
vman-qos
, and
vman-dual-
qos
.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-
config (
write-mem
or
copy run start
) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks and these blocks cannot be reallocated. The
ipv4acl
profile range is from
1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the
ipv6acl
profile which
is from 0 to 10. The
ipv6acl
allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the
reload
conditional nvram-cfg-change
command.
Control and Monitoring
93