Dell Networking S4810, Reference Manual

Page: 919 / 1761

permit
To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or
UDP.
S4810
Syntax
permit { ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command syntax if you know the filter’s
sequence number
• Use the
no permit { ipv6-protocol-number | icmp | ipv6 | tcp |
udp}
command
Parameters
ip-protocol-
number Enter an IPv6 protocol number. The range is from 0 to 255.
icmp Enter the keyword
icmp
to filter internet Control Message
Protocol version 6.
ipv6 Enter the keyword
ipv6
to filter any internet Protocol
version 6.
tcp Enter the keyword
tcp
to filter the Transmission Control
protocol.
udp Enter the keyword
udp
to filter the User Datagram Protocol.
Defaults Not configured.
Command
Modes ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
IPv6 Access Control Lists (IPv6 ACLs)
919