Dell Networking S4810, Reference Manual

Page: 536 / 1761

Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Example
(Summary)
Dell(conf)# show qos dcb-input
dcb-input pfc-profile
pfc link-delay 32
pfc priority 0-1
dcb-input pfc-profile1
no pfc mode on
pfc priority 6-7
show stack-unit stack-ports pfc details
Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC Operational
mode on each unit with the configured priorities, link delay, and number of pause packets sent and
received.
S4810
Syntax
show stack-unit {all | stack-unit } stack-ports {all | port-
number } pfc details
Parameters
stack-unit Enter the stack unit.
port-number Enter the port number.
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
536
Data Center Bridging (DCB)