Dell Networking S4810, Reference Manual

Page: 856 / 1761

The
access-group
option supports only the equal to (
eq
) operator in TCP ACL
rules. Port operators not equal to (
neq
), greater than (
gt
), less than (
lt
), or
range
are not supported in access-group option (refer to the following example). ARP
packets (
arp
) and Ether-type (
ether-type
) are also not supported in the
access-
group
option. The entire rule is skipped to compose the filter.
The
access-group
option pertains to:
• IP protocol number: from 0 to 255
• Internet control message protocol (
icmp
) but not the ICMP message type (from
0 to 255)
• Any internet protocol (
ip
)
• Transmission Control Protocol (
tcp
) but not on the
rst
,
syn
, or
urg
bits
• User Datagram Protocol (
udp
)
In the case of ambiguous access control list rules, the
debug ip packet
access-control
command is disabled. A message appears identifying the error
(refer to the Example below).
Example (Error
Messages)
Dell#debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is
turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
S4810
Syntax
ip address ip-address mask [secondary]
To delete an IP address from an interface, use the
no ip address [ ip-
address ]
command.
Parameters
ip-address Enter an IP address in dotted decimal format.
mask Enter the mask of the IP address in slash prefix format (for
example, /24).
secondary (OPTIONAL) Enter the keyword
secondary
to designate the
IP address as the secondary address.
856
IPv4 Routing