Dell Networking S4810, Reference Manual

Page: 422 / 1761

When you apply a default route to a BGP peer or peer group using the
neighbor
default-originate
command, changes to the configured default route-map
are applied to the BGP peer or peer group only after a delay of 15 seconds. As a
result, you must wait for a period of 15 seconds before manually resetting BGP
using the
clear ip bgp
command.
In case of eBGP, the
neighbor default-originate
command does not
support extended-community as a non-transtive route-map attribute.
You cannot set this configuration for a peer that is associated with a peer group.
Similarly, you cannot associate a peer to a peer group if that peer is already
configured with these settings.
In order that settings corresponding to the
neighbor default-originate
command take effect, you must execute the
clear ip bgp
command
immediately after you execute the
neighbor default-originate
command.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
S4810
Syntax
neighbor { ip-address | peer-group-name } description text
To delete a description, use the
no neighbor { ip-address | peer-group-
name } description
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Defaults Not configured.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
422
Border Gateway Protocol