Dell Networking S4810, Reference Manual

Page: 1223 / 1761

• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0) Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information The following describes the
show ip ospf process-id interface
command
shown in the following example.
Item Description
GigabitEthernet... This line identifies the interface type slot/port and the status
of the OSPF protocol on that interface.
Internet Address... This line displays the IP address, network mask and area
assigned to this interface.
Process ID... This line displays the OSPF Process ID, Router ID, Network
type and cost metric for this interface.
Transmit Delay... This line displays the interface’s settings for Transmit Delay,
State, and Priority. In the State setting, BDR is Backup
Designated Router.
Designated
Router... This line displays the ID of the Designated Router and its
interface address.
Backup
Designated... This line displays the ID of the Backup Designated Router
and its interface address.
Timer intervals... This line displays the interface’s timer settings for Hello
interval, Dead interval, Transmit Delay (Wait), and Retransmit
Interval.
Hello due... This line displays the amount time until the next Hello
packet is sent out this interface.
Open Shortest Path First (OSPFv2 and OSPFv3)
1223