Dell Networking S4810, Reference Manual

Page: 1395 / 1761

interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094.
connected (OPTIONAL) Enter the keyword
connected
to filter only
directly connected routes.
isis (OPTIONAL) Enter the keyword
isis
to filter only IS-IS
routes.
ospf (OPTIONAL) Enter the keyword
ospf
to filter all OSPF routes.
static (OPTIONAL) Enter the keyword
static
to filter manually
configured routes.
Defaults Not configured.
Command
Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Related
Commands ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.
Routing Information Protocol (RIP)
1395