Dell Networking S4810, Reference Manual

Page: 431 / 1761

A neighbor may keep its configuration after it was added to a peer group if the
neighbor’s configuration is more specific than the peer group’s, and the neighbor’s
configuration does not affect outgoing updates.
A peer group must exist before you add a peer to it. If the peer group is disabled
(shutdown) the peers within the group are also disabled (shutdown).
In BGP, you cannot associate a peer to a peer-group without configuring the
remote-as for Internal BGP (IBGP) or External BGP (EBGP).
This command automatically restarts the neighbor session for the configuration to
take effect.
Related
Commands
clear ip bgp — resets BGP sessions.
neighbor peer-group (creating group) — creates a peer group.
show ip bgp peer-group — views BGP peers.
show ip bgp neighbors — views BGP neighbors configurations.
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
S4810
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the
no neighbor peer-group-name peer-group
command.
Parameters
peer-group-
name Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Border Gateway Protocol
431