Dell Networking S4810, Reference Manual

Page: 1667 / 1761

61
Tunneling
Tunneling is supported on the S4810 platform.
tunnel-mode
Enable a tunnel interface.
S4810
Syntax
tunnel mode { ipip | ipv6 | ipv6ip }[ decapsulate-any ]
To disable an active tunnel interface, use the no tunnel
mode
command.
Parameters
ipip Enable tunnel in RFC 2003 mode and encapsulate IPv4
and/or IPv6 datagrams inside an IPv4 tunnel.
ipv6 Enable tunnel in RFC 2473 mode and encapsulate IPv4
and/or IPv6 datagrams inside an IPv6 tunnel.
ipv6ip Enable tunnel in RFC 4213 mode and encapsulate IPv6
datagrams inside an IPv4 tunnel.
decapsulate-
any (Optional) Enable tunnel in multipoint receive-only mode.
Defaults None
Command
Modes INTERFACE TUNNEL
Command
History
Version 9.4(0.0) Added the decapsulate-any command.
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To enable a tunnel interface, use this command. You must define a tunnel mode
for the tunnel to function. If you previously defined the tunnel destination or
source address, the tunnel mode must be compatible.
Including the decapsulate-any option causes the command to fail if any of the
following tunnel transmit options are configured: tunnel destination, tunnel dscp,
tunnel flow-label, tunnel hop-limit, or tunnel keepalive. Conversely, if you
configure any tunnel allow-remote entries, the
tunnel—mode
command fails
unless the decapsulate-any option is included
Tunneling
1667