Dell Networking S4810, Reference Manual

Page: 1515 / 1761

Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Example
Dell#conf
Dell(conf)# ip ssh rhostsfile flash://shosts
Dell(conf)#
Usage
Information
This command specifies the rhost file used for host-based authentication. This
creates/
file overwrites the
flash:/ADMIN_DIR/ssh/shosts
file and deletes
the user-specified file. Even though this command is a global configuration
command, it does not appear in the running configuration because you only need
to run this command once.
This file contains hostnames and usernames, for which hosts and users, rhost-
authentication can be allowed.
NOTE: For
rhostfile
and
pub-key-file
, the administrator must FTP the
file to the switch.
ip ssh rsa-authentication (Config)
Enable RSA authentication for the SSHv2 server.
S4810
Syntax
ip ssh rsa-authentication enable
To disable RSA authentication, use the
no ip ssh rsa-authentication
enable
command.
Parameters
enable Enter the keyword
enable
to enable RSA authentication for
the SSHv2 server.
Security
1515