Dell Networking S4810, Reference Manual

Page: 1140 / 1761

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced on the E-Series.
tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
S4810
Syntax
tc-flush-standard
To disable, use the
no tc-flush-standard
command.
Defaults Disabled.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced
Usage
Information By default, Dell Networking OS implements an optimized flush mechanism for
MSTP. This mechanism helps in flushing the MAC addresses only when necessary
(and less often) allowing for faster convergence during topology changes.
However, if a standards-based flush mechanism is needed, this
knob
command
1140
Multiple Spanning Tree Protocol (MSTP)