Dell Networking S4810, Reference Manual

Page: 1351 / 1761

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information To access this command, enter the
class-map
command. After the class map is
identified, you can configure the match criteria. For class-map match-any, a
maximum of five ACL match criteria are allowed. For
class-map match-all
,
only one ACL match criteria is allowed.
Related
Commands
class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
S4810
Syntax
match ip dscp dscp-list [set-ip-dscp value ]
To remove a DSCP value as a match criteria, use the
no match ip dscp dscp-
list [set-ip-dscp value ]
command.
Parameters
dscp-list Enter the IP DSCP values that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 63.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command
Modes CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Quality of Service (QoS)
1351