Dell Networking S4810, Reference Manual

Page: 684 / 1761

Primary : GigabitEthernet 0/16 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150
msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
Dell#
Example (2
Summary)
Dell#show frrp 2 summary
Dell#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------
2 Up Master 2 11-20, 25, 27-30
Dell#
Related
Commands protocol frrp — enters the resilient ring protocol and designate a ring identification.
timer
Set the hello interval or dead interval for the Ring control packets.
S4810
Syntax
timer {hello-interval milliseconds }| {dead-interval
milliseconds }
To remove the timer, use the
no timer {hello-interval
[ milliseconds ]}| {dead-interval milliseconds }
command.
Parameters
hello-interval
milliseconds
Enter the keyword
hello-interval
then the time, in
milliseconds, to set the hello interval of the control packets.
The milliseconds must be entered in increments of 50
millisecond; for example, 50, 100, 150, and so on. If an
invalid value is entered, an error message is generated. The
range is from 50 to 2000 ms. Default:
500 ms .
dead-interval
milliseconds
Enter the keyword
dead-interval
then the time, in
milliseconds, to set the dead interval of the control packets.
The range is from 50 to 6000 ms. Default:
1500 ms .
NOTE: The configured dead interval must be at least
three times the hello interval.
Defaults
• 500 ms for
hello-interval milliseconds
• 1500 ms for
dead-interval milliseconds
684
Force10 Resilient Ring Protocol (FRRP)