Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
546
IV Appendix
No. Content Remark
0262
Mistake in programming causes there is not intersection between arc and
straight line of current tool radius in the course of C tool nose radius
compensation
0263
There are too non movement commands in C too radius compensation, the
buffer overflows
0270
The circle centre angle of circular screw interpolation is not in the range of
45°~135°or 135°~225°or 225°~315°or -45°~45.modify the program please
0276
The end point and angle value using direct input of drawing dimensions are
not applicable or normal
0277
The instruction isn't allowed in direct input of drawing dimensions or
non-motion blocks are too much
0278
The middle block using direct input of drawing dimensions cann't be the last
block of a loop
0279
Angle is not normal or the end point cann't be calculated in direct input of
drawing dimensions
0281 The linear chamfer length is too length
0282 The arc chamfer radius is too big
0283 The linear chamfer length is too big or the arc data is mistaken
0284 The arc chamfer radius is too big or the arc data is mistaken
0285 The linear chamfer length is too big or the arc data is mistaken
0286 The arc chamfer radius is too big or the arc data is mistaken
0287 The linear chamfer length is too big or the intersection is not on the arc
0288 The arc chamfer radius is too big or the intersection is not on the arc
0289 The chamfer cannot be executed in end position
0290
Cannot start the polar coordinate and the cylinder interpolation in C tool
compensation state or G99
0291
The linear axis or rotary axis of the polar coordinates does not correspond to
No.189 or the linear axis attribution setting is mistaken
0292
Execute the length compensation of all axes before starting the polar
coordinates
0293 X cannot be negative or 0 in G16/G15
0294
Have used the command which cannot be used to the polar coordinates and
the cylinder interpolation
0295
C tool compensation is not cancelled in the polar coordinates and the
cylinder interpolation
0296 Finish machining counts of cylindrical interpolation loop are over 9999
0297
Cann't cut the workpiece in cylindrical interpolation loop because X
orientation and cutting direction are not same
6000 CNC emergent stop is failure(restart the CNC)
6001 No program zero is defined
6003 Feed speed is too high
6004 Spindle stopped accidentally, please stop feeding and check the spindle
6005
Not define the highest speed of some gear, please check the parameter
No.37~No.40
6010 Spindle doesn't rotate,or speed is too slow in thread cutting
