Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
430
Ⅲ
Connection
Bit7 1: Show clock
0: Conceal clock
Bit4 1: Tool life management group skip active
0: Tool life management group skip inactive
Bit3 1: Tool life management active in MDI mode
0: Tool life management inactive in MDI mode
Bit2 1: Tool life counting type 2, by times
0: Tool life counting type 1, by times
Bit1 1: Tool nose radius offset active
0: Tool nose radius offset inactive
Bit0 1: Tool life management active
0: Tool life management inactive
0 0 3 HTCHG *** PCOMP TCOMP CDCOMP *** *** OIM
Bit7 1: High efficiency tool-change function enabled
0: High efficiency tool-change function disabled
Bit5 1: Pitch error offset active
0: Pitch error offset inactive
Bit4 1: Tool offset by coordinate offset
0: Tool offset by move
Bit3 1: Tool compensated by the shift of coordinate system do not memorize the unexecuted tool
compensation
0: Tool compensated by the shift of coordinate system memorize the unexecuted tool
compensation
Bit0 1: Offset automatically change in metric and inch conversion
0: Offset not change in metric and inch conversion
0 0 4 ABOT
RDRN DECI
ORC ***
*** PROD SCW
Bit7 1: do not memorize absolute coordinate in power-down
0: memorize the absolute coordinate in power-down
Bit6 1: G00 is rapid traverse speed in dry run mode
0: G00 is manual feedrate in dry run mode
Bit5 1: DEC signal is high level for machine zero return
0: DEC signal is low level for machine zero return
Bit4 1: Tool offset by radius
0: Tool offset by diameter
Bit1 1: Relative position for programming in POSITION page
0: Relative position involving offset in POSITION page
Bit0 1: Inch system for min. code unit, active after repowering
0: Metric system for min. code unit, active after repowering
0 0 5 *** *** SMAL M30 *** POSRE
PPD
PCMD
Bit 5 1: Manual spindle gear change during the execution of S code;
0: Automatic spindle gear change during the execution of S code;
Bit 4 1: Cursor returns to the head of the program after the execution of M30;
0: Cursor does not return to the head of the program after the execution of M30;
