Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Chapter 9 AUTO Operation
307
Ⅱ
Operation
CHAPTER 9 AUTO OPERATION
9.1 Automatic Run
9.1.1 Selection of a Program Running
Refer to Section 6.3.
9.1.2 Start of Automatic Run
1. Press
to select the Auto mode;
2. Press
to start the program, and the program automatically runs.
Note: Since the program execution begins from the block where the cursor locates, before pressing the
, make a check whether the cursor is located at the block to be executed.
9.1.3 Stop of Automatic Run
z
Stop by code (M00)
1. M00
After the block containing M00 is executed, the auto run is stopped. So the modal function and
state are all reserved. Press the
or the external run key, the program execution continues.
2. M01
Press
and the optional stop indicator is ON and the function is valid. After the block with
M01 is executed, the system stops the automatic run, the modal function and the state are saved.
Press
or the external run key, and the program continuously runs.
z
Stop by a relevant key
1. In Auto run, by pressing
or external pause key, the machine keeps the following state:
(1) The machine feed slows down to stop;
(2) The modal function and state are reserved;
Note
！
The key functions of GSK980TDi machine panel are defined by PLC program
(ladders), please refer to the materials by the machine builder for their
significance.
Please note that the following description for the keys function in this chapter
is based on GSK980TDi standard PLC program!
