Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
332
Ⅱ
Operation
2) Alteration by bit:
a) Turn on the parameter switch;
b) Enter the MDI mode;
c) Move the cursor to the parameter number to be set
（
the method is referred to Section
10.4.1 Step c
）
;
d) Press
to enter the bit alteration mode, at the moment, some bit of the parameter
is backlighted. Press
or
to move the cursor to the bit to be altered, then key in 0 or
1;
e) After all parameters setting is finished, the PARM SWT needs to be set to OFF for
security.
Note: After the system enters some bit of the parameter,
or
is pressed to escape from the
alteration mode, and the cursor stops the parameter number .
Example:
Set the Bit3 of the bit parameter No.001 to 1, and the other bits remains unchanged.
Move the cursor to No.001 according to the above steps, press
to skip to some bit of the
parameter, and move the cursor to Bit3. The display is shown below:
Input 1, and the parameter alteration is done.
