Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
264
Ⅱ
Operation
2) Press
to enter the next menu, which is shown below:
3) When the current content is changed(after modification, copy or deletion),
is pressed
to recover the previous content before the copy;
4) Recover and cancel are matched. Press
，
to cancel the previous operation.
Note: Up to 10 previous steps can be retreated by using the retraction function;
6.1.10 Circle Command Aided Programming
The cycle G command should be input more parameter commands. This function is the
programming guiding function for each cycle command; Operator can easily finish the programming
operation for the cycle command by the miscellaneous programming function. There are two
methods to enter the miscellaneous function, refer to the following steps:
Method 1:
1
）
Press
soft key enter to edit mode
，
press
soft key, enter to the program page set and
then shift to the program content page, so that the cursor does not the line of that the cycle
command locates, which is shown below:
