Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Chapter 3 Parameters
467
Ⅲ
Connection
Bit6 1: External cycle start signal (ST) inactive)
0: External cycle start signal (ST) active
Bit5 1: External SP signal inactive
0: External SP signal active with external dwell switch needed, otherwise CNC shows “Pause”.
Bit4 1: Not detect software stroke limit
0: Detect software stroke limit
Bit3 1: Emergency stop inactive
0: Emergency stop active
Bit1 1: Software limit is inactive after power-on and before machine zero return;
0: Software limit is active after power-on and before machine zero return;
Bit0 1: When Arriving stored travel position, CNC is stopped slowly
0: When Arriving stored travel position, CNC is stopped immediately
0 4 5
LT1n1
0 4 6
LT1n2
［
Data type
］
Word
axis
［
Data meaning
］
LT1n1: Maximum stroke on positive direction; LT1n2: Maximum stroke on
negative direction
［
Data Unit
］
Setting unit
IS-B
IS-C
Metric machine
0.001 mm
0.0001 mm
Inch machine
0.0001 inch
0.00001 inch
［
Data range
］
-99999999
～
99999999
Note:
When bit 2 of parameter No. 001 set diameter programming, X axis is set by diameter system; when bit 2 set
radius programming, X axis is set by radius system.
1 0 0
LTMAX_2
1 0 1
LTMIN_2
［
Data type
］
Word
axis
［
Data meaning
］
Stored stroke limit 2 of each axis, LTMAX_2 top stroke position along with the
positive direction, LTMIN_2 top stroke position along with the negative direction.
［
Data unit
］
Setting unit
IS-B
IS-C
Metric machine
0.001 mm
0.0001 mm
Inch machine
0.0001 inch
0.00001 inch
［
Data range
］
-99999999
～
99999999
1 0 2
LTMAX_3
1 0 3
LTMIN_3
［
Data type
］
Word
axis
［
Data meaning
］
Stored stroke limit 3 of each axis, LTMAX_3 top stroke position along with the
positive direction, LTMIN_3 top stroke position along with the negative direction.
［
Data unit
］
