Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
360
Ⅱ
Operation
Φ
13
5
3)
Release the tool along X when Z does not move, and stop the spindle, execute G50 Z0 in
PROGRAM->MDI page in MDI mode to set the coordinate of Z axis;
4)
Switch to tool offset page and input Z0 to No.001 offset;
5)
Move the tool and make it to cut along the outer circle of the part;
6) Release the tool along Z when X does not move, and stop the spindle, measure the
dimensions of the outer circle of the part (e.g. The measuring value is 135mm);
7)
Execute G50 X135 command in PROGRAM>MDI page in MDI mode to set the coordinate
of X axis;
8)
Switch to tool offset page, and input X135 to No.001 offset;
9)
Move the tool to a safe position, and change No. 002 tool;
10) Start the spindle and move the tool to the tool-setting point, as A point in the following
figure;
