Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Appendix VI Alarm List
545
IV Appendix
No. Content Remark
0200 Circle radius is zero or undefined
0201 The distance of circle start and end point is too small
0202 Circle start point and center of the circle are the same as one point
0203 The error of circle radius is out of range of the parameter NO.154
0204 Not specify middle point in three point circle instruction
0205 Three points are a line in three point circle instruction
0206 Helical interpolation is invalid if defined plane hasn't movement
0208 Long radius or short radius of ellipse is zero or undefined
0209 P value of parabola is zero or undefined
0227 Spindle positioning axis isn't allowed to execute the function
0228 Spindle positioning axis and some code cann't be in the same block
0229 Unusable code or command in synchro control
0232 Specify the axis movement command in M29 or G84/G88
0233 Rigid tapping signal (G61.0) in rigid tapping mode is abnormal
0234 Specify M29 repetitively or not input M29 before rigid tapping
0235
The spindle must be oriented, M29 cannot be with G84/G88 in the same
block when rigid tapping
0236
Set the axis used to the spindle control to the rotary axis before the rigid
tapping/rigid thread machining
0237 Have used unnecessary commands in rigid tapping or rigid screw
0238
Have not selected the spindle used to the rigid tapping for the multi-spindle
function device when rigid tapping
0239 Cannot switch the spindle used to the tapping when rigid tapping
0251
Mistake in programming causes an error of C tool nose radius
compensation
0252
Mistake in programming causes an end point of arc machining is not on the
arc in the course of C tool nose radius compensation
0253
Mistake in programming causes there are the same coordinates for two
neighboring points not to execute C tool nose radius compensation
0254
Mistake in programming causes there are the same coordinates between
center point and starting point of arc not to execute C tool nose radius
compensation
0255
Mistake in programming causes there are the same coordinates between
center point and end point of arc not to execute C tool nose radius
compensation
0256
Arc radius is less than that of tool nose to cause not to execute C tool nose
radius compensation
0257
Mistake in programming causes there is not intersection of two arcs of
current tool radius in the course of C tool nose radius compensation
0258 Specify one arc command as executing C tool nose radius compensation
0259 Specify one arc command as canceling C tool nose radius compensation
0260 There is excessive cutting as checking C tool nose radius compensation
0261
Mistake in programming causes there is not intersection between straight
line and arc of current tool radius in the course of C tool nose radius
compensation
