Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Chapter 6 Program Edit & Management
281
Ⅱ
Operation
The
will be cancelled by
soft button, only the programming path is then drawn.
6) Display the cutter compensation C
If the program in the cutter compensation C, and press the
soft button; the programming
path and the cutter compensation C path will display, and the cutter compensation C shows with red,
refer to the following figure:
The
will be cancelled by
soft button; only the programming path is drawn.
6.10.3 Command Display of Path Preview
(Single dotted-line)
：
G00
(Double full-line)
：
G01/G02/G03/G05/G122/G124/G144/G146
(Thread line)
：
G32
(Symmetric line): Mirror image path symmetric axis
(Single full-line): The connection cable of the cutting path and
symmetric cables in the mirror image path.
Explanations:
(1) G28, G30: This section will not show if there is no intermediate point to be specified; if the
intermediate point is specified in command, the drawing will be performed to the intermediate point,
and part of the figure where from intermediate point to the mechanical zero will not be drawn;
