Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Chapter 3 Manual Operation
241
Ⅱ
Operation
and there are 4 steps of F0, 25%, 50%,100% for the override.(F0 is set by data parameter No.032)
The rapid override is active under the following conditions:
(1) G00 rapid traverse (2) Rapid traverse in canned cycle
(3) Rapid traverse in G28 (4) Manual rapid traverse
3.2 Other Manual Operations
3.2.1 Spindle CCW, CW, Stop Control
: In Manual mode, the spindle rotates counterclockwise if pressing this key;
: In Manual mode, the spindle stops if pressing this key;
: In Manual mode, the spindle rotates clockwise if pressing this key.
3.2.2 Spindle JOG
: At the moment, the spindle is in JOG state.
Functional description:
Press
to enter JOG mode, and the spindle JOG function ON/OFF is executed only when
the spindle is in the state of stop.
In spindle JOG mode, by pressing
key, the spindle rotates counterclockwise for jogging;
by pressing
key, the spindle rotates clockwise for jogging. The jog time and speed are set by
data parameter No.108 and No.109 respectively.
When the spindle JOG rotates,
is pressed to stop the spindle JOG rotation, the spindle
brake signal is not output when the JOG rotation stops.
K10.4 is set to 1, the spindle JOG is valid in any mode. In Auto or MDI mode, the spindle is in the
JOG rotation state, the program closes the spindle JOG rotation and the JOG function.
Parameter setting:
PLC parameter K104 1/0: the spindle JOG is valid in any mode/Manual, MPG, Zero return mode.
Data parameter No.108: spindle JOG time
Data parameter No.109: rotary speed in spindle JOG.
3.2.3 Cooling Control
: In Manual mode, press this key, the cooling is switched on/off.
Parameter setting: PLC parameter K10.1 1/0: the spindle lubricating and cooling output
remains/closes in reset.
