Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Chapter 11 Data Setting
331
Ⅱ
Operation
11.4.1 State Parameter
1)
Byte alteration:
a) Turn on the parameter switch;
b) Enter the MDI mode;
c) Move the cursor to the parameter number to be set:
Method 1: Press
or to enter the page containing the parameter to be set, press
or
key to move the cursor to the parameter number to be set;
Method 2: Press
(or
) , and input the parameter number in the pop-up
dialogue box, at last, press
.
4) Key in a new parameter value;
5) Press
key, the parameter value is entered and displayed.
6) For security, the PARM SWT needs to be set to OFF after all parameter settings are
finished.
Example:
Set the bit parameter No.001 Bit 3(STEP/MPG) to 1, and the other bits remain unchanged.
Move the cursor to No.001, input 00011000 by sequence according to the above steps. The
display is shown below:
Press
to finish the parameter alteration. The page is shown below:
