Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
352
Ⅱ
Operation
13.2 Preparatory Before Communication
13.2.1 Communication Cable Connection
DB9 male plug is inserted into CN51 communication interface of the CNC, DB9 female plug is
inserted in to DB9-male serial port (COM0 or COM1) of PC. Connect the communication cable when
PC and CNC are turned off.
13.2.2 Communication Setting Baud Rate
Setting the baud rate of communication ensures that the baud rate of PC is the same that of the
CNC communication.
The communication baud of the serial port is set by No.044; click [Communication Setup] in the
menu [Communication] and the system pops up a dialog box as follows:
Set the serial port and baud rate. The baud rate should be not less than 4800 when the data is
transmitted between CNC and PC, the factory setting is :115200.
13.2.2.1 Network Cable Connection
Use the common network cable, one terminal connects with the internet access of GSK980TDi,
the other one directly connects the Computer or Router access.
13.2.2.2 Communication IP Setting
Set the IP address of communication, so that the IP address between PC and CNC
communication are consistant.
The IP setting of the GSK980TDi is as follows:
－
>
and then set the IP address
and sub-net mask, etc. after entering the system IP setting page, refer to the following figure:
