Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
274
Ⅱ
Operation
5) Repeat step 3 and 4 to display the saved programs one by one.
6.3.3 Direct Confirmation
1) Select Edit or Auto mode (must be in non-run state);
2) Press
to enter the program interface. When the system is not in “Local Directory” ,
is pressed, which displays is shown below:
3) Press
，
to move the cursor to the program name which is to be selected.
4) Press
(or
), and the selected program is opened and the CNC skips to “PRG.
CONTENT” page.
Note: when the CNC is connected with the U disk, the above similar method is referred to open the program in
the U disk.
6.4 Executing a Program
After the program to be executed is selected by the method in OPERATION, Section 6.3, select
the Auto mode, then press
key (or external cycle start key), the program will be executed
automatically.
6.5 Renaming a Program
Methods of renaming a program is divided into two:
Method 1:
1) Select Edit mode, press
to enter the program interface, and in necessity press
to enter PRG CONTENT page (must be in Insert, Alter state):
