Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
316
Ⅱ
Operation
z
When the non-block reference point set is performed. (The treatment is consistent with the
manual reference point return)
z
When performing the G50 workpiece coordinate system setting. (In this case, the workpiece
coordinate is one by G50, simultaneously, the interruption value is eliminated)
z
System restarts. The MPG interruption value will be also cleared after the system is power off,
but the workpiece coordinate system holds, and therefore, the system is turned off after the
MPG interrupt, the workpiece coordinate offset generated in the MPG interruption will always
enabled, and it can not recover to the previous state of interruption.)
9.4.4 MPG Interruption Display Page
The Bit 1 of state parameter No.0012 should be set to “1” before using the MPG interruption
function, and then lead in the dedicated PLC program;
Press the
soft function button to enter its corresponding page after controlling the
button, refer to the following figure:
The following 4 data can be simultaneously displayed at the MPG interruption display page:
1) Input unit:
The MPG interruption movement value in the input unit means the specified movement
value of MPG interruption based upon its least input command unit.
2) Output unit:
The MPG interruption movement value in the output unit means the specified movement
value of MPG interruption based upon its least output movement unit.
3) Relative coordinate:
The position at the relative coordinate system and the position of the current relative
coordinate system may generate the change of the interruption value due to the interruption of
the MPG.
4) Residual movement value:
The residual movement value at the current block is irrelevant to the MPG interruption.
The MPG interruption movement value is cleared when the manual reference point end return is
performed along each axis.
Note 1: In the MPG interruption page, the letters of the coordinate axis name should be marked by
in
the MPG interruption axis.
Note 2
：
Manually clear the MPG interruption value by the soft button of the MPG interruption page; the
