Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK980TDi Turning CNC System User Manual
434
Ⅲ
Connection
1 7 2 *** MST MSP
MOT
ESP *** LZR MOTDEC
Bit6 1: External cycle start signal (ST) inactive)
0: External cycle start signal (ST) active
Bit5 1: External SP signal inactive
0: External SP signal active with external dwell switch needed, otherwise CNC shows
“Pause”.
Bit4 1: Not detect software stroke limit
0: Detect software stroke limit
Bit3 1: Emergency stop inactive
0: Emergency stop active
Bit1 1: Software limit is inactive after power-on and before machine zero return;
0: Software limit is active after power-on and before machine zero return;
Bit0 1: When Arriving stored travel position, CNC is stopped slowly
0: When Arriving stored travel position, CNC is stopped immediately
1 7 4 PARTSET
***
TRPMO
D
TRP KEY1 THDTLM
OD
THDA CKSPD
Bit7 1:Continue to run part program while current machining workpiece counts reach to max.
counts.and machining workpiece counts accumulate
0:Continue to run part program while current machining workpiece counts reach to max.
counts.and machining workpiece counts restart
Bit5 1:Screw repair mode use follow the spindle with encoder
0:Screw repair mode use interpolation with servo spindle
Bit4 1:Thread repair function is valid
0:Thread repair function is invalid
Bit3 1: Program switch ON at power on
0: Program switch OFF at power on
Bit2 1:Thread tailing mode tailling according angle;
0:Thread tailing mode rapid tailing.
Bit1 1:Thread cut is exp. acc&dec
0:Thread cut is lin. acc&dec
Bit0 1:Whether detect the spindle speed is too slow in thread cutting don't detect\
0:Whether detect the spindle speed is too slow in thread cutting do detect
1 7 5 SPFD SAR THDA VAL5
VAL4
VALY
VALZ VALX
Bit7 1: In cutting feed, do not permit the spindle stopping rotation; the spindle stops, the feed also
stops when the system appears No.404 alarm cutting
0: In cutting feed, permit the spindle stops rotation; the spindle stops rotation, but the feed
does not stop
Bit6 1: Detect spindle SAR signal prior to cutting
0: Not detect spindle SAR signal prior to cutting
Bit5 1: Thread machining is the exponential acceleration/deceleration
0: Thread machining is the linear acceleration/deceleration
Bit4 1: 5
th
movement key
is positive,
is negative
0: 5
th
movement key
is positive,
is negative
