Siemens SINAMICS G120, Список руководств

Страница: 579 / 1256

SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890
579
2 Parameters
2.2 List of parameters
Description: Displays the Safety Integrated status on processor 1.
Dependency: Refer to: r9872
Note: For bit 00:
When STO is selected, the cause is displayed in bits 16 ... 21.
For bit 05:
When SS1 is selected, the cause is displayed in bits 22 and 23.
For bit 18:
When the bit is set, STO is selected via PROFIsafe or via F-DI.
For bit 19:
With SMM encoderless no actual value sensing is possible on account of OFF2.
SMM: Safe Motion Monitoring
For bit 22, 23:
These bits show via which path the SS1 was triggered, i.e. what has started the SS1 delay time.
If the SS1 delay time is not started (e.g. because an STO is triggered at the same time), neither of the two bits is set.
r9772.0...25 CO/BO: SI status (processor 1) / SI status P1
CU250S_V_DP
CU250S_V_PN Access level: 2 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 2804
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 STO selected on processor 1 Yes No 2810
01 STO active on processor 1 Yes No 2810
02 SS1 delay time active on processor 1 Yes No 2810
04 SBC requested Yes No 2814
05 SS1 selected on processor 1 (Basic
Functions) Yes No -
06 SS1 active on processor 1 (Basic
Functions) Yes No -
07 STO terminal state on processor 1 (Basic
Functions) High Low -
09 STOP A cannot be acknowledged active Yes No 2802
10 STOP A active Yes No 2802
15 STOP F active Yes No 2802
16 STO cause: Safety comm. mode Yes No -
17 STO cause selection via terminal (Basic
Functions) Yes No -
18 STO cause selection via Safe Motion
Monitoring (SMM) Yes No -
19 STO cause actual value missing Yes No -
20 STO cause selection PROFIsafe (Basic
Functions) Yes No -
21 STO cause selection on the other
monitoring channel Yes No -
22 SS1 cause selection terminal (Basic
Functions) Yes No -
23 SS1 cause selection PROFIsafe (Basic
Functions) Yes No -
25 STO cause selection via terminal on the
Power Module Yes No -