Data I/O UniSite-xpi, User Manual

Page: 34 / 413

2. Setup and Installation
2-4 UniSite-xpi User Manual
Installing a Large Module To install a large module, follow the steps below:
1. Insert the two retaining hooks on the bottom of the large module into
the two slots on the top right side of UniSite-xpi. Figure 2-1 shows a
large module already inserted into UniSite-xpi.
2. Carefully lower the back of the large module until the module
connector touches its mating connector on UniSite-xpi.
3. To ensure complete contact, firmly press down on the rear of the
large module.
You do not need to use excessive force when pressing on the module.
CAUTION: You can damage UniSite-xpi by exerting too much force on
the module.
Removing a Module
To remove a large module or a small module, follow the steps below:
1. Make sure you are not performing any device operations, such as
loading, programming, or verifying.
2. Make sure the Active LED on the module is not lit.
3. Remove any devices in the module.
4. Lift the rear of the module until the retaining hooks on the front of
the module are disengaged from the slots on the top of UniSite-xpi.
5. Set the module aside.
Figure 2-1
Installing a Small Module
0052-5
RETAINING HOOKS