Data I/O UniSite-xpi, User Manual

Page: 131 / 413

3. Getting Started
UniSite-xpi User Manual 3-59
Review
Load the data into RAM, then select Program Device from the Main
Menu. You will see one of two parameter-entry screens: the simple
Non-default screen or the complex All Parameters screen. Press F4 to
toggle between the two parameter-entry screens. Change the parameters
if necessary. Press E
NTER
to begin the programming.
When UniSite-xpi is finished programming, it displays an 8-digit
sumcheck of the data programmed into the device. (UniSite-xpi displays a
4-digit sumcheck when you program a logic device.)
Session 21: Verifying a Device
Once you have programmed a device, you can perform a number of
different device checks and programming tests on the device. For the rest
of this Session we will refer to device checks and programming tests as
verify operations.
During this Session, you will verify a device with a data file stored in
RAM.
Before You Begin
Make sure you have completed Session 1, an introduction to the
UniSite-xpi interface. Also make sure you have completed Session 9,
which covers programming a device.
Can I Use Another
Device?
If you do not have an AMD 27256 (the device we are going to use for this
Session), then go to the Select Device screen and select the device you are
going to program. Keep in mind that the device you select might not have
the same capabilities as the AMD 27256. For example, the AMD 27256
supports Electronic ID while the Hitachi 27256 does not.
Parameter Screens
Select Verify Device from the Main Menu. The dialog window displays
the Verify Memory Device screen, shown in Figure 3-59.
Figure 3-59
The All Parameters Verify Screen